Case Study: Replacing Two Commercial Water Heaters in a San Jose Building
Table of Contents
When a commercial building in San Jose suddenly lost its hot water, our technician found one of its two 100-gallon water heaters leaking from the bottom, a sign the tank itself had failed. Because both heaters were the same age, we replaced both, and the tenants had hot water again.
For homes, see our electric water heater service and hot water recirculation pumps.
This is a project write-up. For commercial water heater service, sizing and replacement, see our commercial water heaters page.
The Problem
In the water heater closet, our technician found that one of the property’s two 100-gallon water heaters was leaking from the bottom, which had left the whole building without hot water. A leak from the bottom of a tank means the tank itself has failed, so repair wasn’t an option. We photographed the heater’s information plate for the Homeowners Association (HOA) in case they wanted to review replacement options.
The Solution
Both heaters were the same age, so the best choice for long-term reliability was to replace both. Our team removed the old units and installed:
- Two new 100-gallon water heaters, connected, with the inlets and outlets carefully capped off for a secure fit
- Four new 1½-inch dielectric unions to prevent corrosion where copper meets steel
- Six 1½-inch no-stop copper couplings, with galvanized nipples and caps, for the gas and water connections
- Two new temperature and pressure (T&P) relief valves
- Seismic straps, fastened and checked, as California requires
Testing
Before finishing, we tested every gas and water connection for leaks, confirmed both heaters were heating properly, and checked that the seismic straps were tight with no movement. With everything working, the building had reliable hot water again.
Takeaways for Property Managers
- A leak from the bottom of a tank means replacement, not repair.
- Paired heaters of the same age usually fail close together; replacing both avoids a second outage.
- Dielectric unions, T&P valves and seismic straps are part of a proper installation, not extras.
- Annual maintenance (flushing, relief valve tests) extends heater life; see water heater maintenance tips and signs your water heater needs repair.
What Affects the Cost of a Commercial Water Heater Replacement?
Commercial jobs vary too much for a single price: one building needs a like-for-like swap of one tank, another needs several heaters, new venting and a permit-driven upgrade. CPI quotes the job as a fixed price before work starts, after seeing the equipment and the site. These are the factors that move the price:
| Factor | Why it matters |
|---|---|
| Size and number of heaters | Larger tanks and higher-input burners cost more, and paired or multiple heaters multiply the equipment and labor. |
| Fuel and venting | Gas heaters need correct venting and combustion air; changing the vent type, or switching to an electric or heat pump unit, adds work. |
| Access | Closets, rooftops, basements and stairs decide how hard it is to move a heavy 100-gallon tank in and out. |
| Connection parts | Dielectric unions, valves, T&P relief valves and their discharge piping, expansion tanks and seismic straps, as in the job above. |
| Permit and inspection | San Jose requires a plumbing permit to install or replace a water heater. |
| Timing | Work scheduled after hours to keep tenants or customers in hot water is billed at after-hours pricing. |
| Removal | Draining, disconnecting and hauling away the old units. |
For residential water heaters, see typical San Jose prices in water heater installation cost.
How a Commercial Water Heater Replacement Works
- Diagnose the failure. Find where the leak or fault is, and read the data plate for the heater’s age, capacity and input.
- Size the replacement. Match the new heaters to the building’s peak hot water demand and recovery needs, not just to the old tanks.
- Pull the permit. The installation is inspected along with the gas, venting and relief valve connections.
- Shut off and drain. Turn off the gas, water and power, drain the old tanks, disconnect them and remove them.
- Set and secure the new heaters. California requires new and replacement water heaters to be braced, anchored or strapped against earthquakes (Health and Safety Code § 19211).
- Connect everything. Water lines with dielectric unions where copper meets steel, the gas line, the venting, and a T&P relief valve with its discharge line on each heater.
- Fill, then start. Fill each tank completely and bleed the air out at a hot water tap before lighting or powering it, then set the temperature.
- Test and hand over. Check every gas and water connection for leaks, confirm the venting works and both heaters heat, check the straps, and pass the inspection.
Planning Ahead: Air District Rules for Gas Water Heaters
The Bay Area Air Quality Management District’s building appliance rules set zero-NOx standards for gas water heaters. Units under 75,000 BTU/hr, typically residential tanks, must meet it if manufactured after January 1, 2027; units from 75,000 BTU/hr to 2 million BTU/hr, typically commercial and multifamily heaters, including tankless units, if manufactured after January 1, 2031. Existing heaters can stay in service, but if your building’s heaters are getting old, it’s worth knowing which kind of replacement will be available when they fail.
Commercial Water Heaters in San Jose
CPI Service installs, repairs and maintains commercial and residential water heaters throughout San Jose and the South Bay, with permits and inspections handled. See how a water heater is installed, water heater installation cost and water heater services. Request a free estimate or call (408) 978-3093.
Frequently Asked Questions
Why replace both water heaters when only one failed?
When paired heaters are the same age, the second is usually close behind. Replacing both at once avoids a second outage and a second service call, and keeps the system balanced.
Do commercial water heaters need seismic straps in California?
Yes. Water heaters must be braced against earthquakes, and the installation is inspected along with the gas, venting and relief valve connections.
Do I need a permit to replace a commercial water heater in San Jose?
Yes. The City of San Jose requires a plumbing permit to install or replace a water heater, and the work is inspected. A licensed contractor normally pulls the permit as part of the job.
What size commercial water heater do I need?
It depends on the building's peak hot water demand: how many fixtures and appliances draw hot water at once, and how quickly the heater must recover. Matching the old tank's size is a starting point, not a sizing method, especially if the building's use has changed.
Can a leaking commercial water heater be repaired?
Not if the tank itself leaks: a leak from the bottom of the tank means the tank has failed and the heater must be replaced. Leaks at fittings, valves or the relief valve, and problems with burners, thermostats or elements, can often be repaired.
How do the Bay Area Air District rules affect commercial gas water heaters?
Under the Air District's building appliance rules, gas water heaters from 75,000 BTU/hr to 2 million BTU/hr, typically commercial and multifamily units, must meet a zero-NOx standard if manufactured after January 1, 2031. Existing heaters can stay in service; the rule matters when you plan the next replacement.
CPI and Alex were extremely helpful when our local church’s water heater kept malfunctioning and needed replacing. From the initial diagnosis, explanation and recommendation of replacement, we always felt that our needs were being tailored to. Not only were they extremely kind, knowledgeable and professional, but they also were diligent and efficient during their time.
We’re truly grateful for their excellent work and would highly recommend CPI to anyone in need of plumbing or heating services, especially for those in larger community buildings like churches like ours.
Stephen S., Google review
Read more reviews →Serving San Jose and the South Bay
CPI Service is based at 2880 Aiello Dr in San Jose and serves homes and businesses across the South Bay and the Peninsula. See all the areas we serve.