(408) 978-3093
Faucet & Fixture

Why Is My Faucet Dripping? Common Causes and How to Fix It

Plumber tightening a kitchen faucet with a wrench
Table of Contents
  1. Common Causes of a Dripping Faucet
  2. Which Type of Faucet Do You Have?
  3. How to Fix a Dripping Faucet
  4. Check Your Water Pressure
  5. What Fixing a Dripping Faucet Costs
  6. When to Call a Plumber
  7. Is Your Toilet Making a Hissing Sound?
  8. Preventive Plumbing Tips
  9. Dripping Faucets in San Jose Homes
  10. Frequently Asked Questions

A dripping faucet wastes water, adds to your bill and usually means a worn part inside. The good news: most drips come from a few inexpensive parts, and many can be fixed in under an hour. In South Bay homes, hard water leaves scale that wears seals and valve seats faster.

San Jose Water’s 2025 water quality report lists average hardness of about 6 to 17 grains per gallon, depending on the source. Here’s what causes faucets to drip and how to fix them.

A drip is easy to ignore, but it adds up. EPA WaterSense says a faucet dripping once a second can waste more than 3,000 gallons a year, and that old, worn faucet washers and gaskets are a frequent cause (EPA).

Common Causes of a Dripping Faucet

  1. A worn cartridge. Most modern single- and double-handle faucets use cartridges; when the seals inside wear, the faucet drips from the spout.
  2. Worn washers. Older compression faucets (with separate hot and cold handles that tighten down) use rubber washers that wear out.
  3. A bad O-ring. Leaks around the handle usually mean a worn O-ring.
  4. A corroded valve seat. Hard water scale and corrosion where the washer meets the faucet body cause drips at the spout.
  5. High water pressure. Pressure above 80 psi pushes water past seals and wears parts faster.
  6. Loose or damaged parts. Packing nuts and screws loosen with use.

Which Type of Faucet Do You Have?

The repair depends on what’s inside the faucet. There are four common types:

  • Compression faucets have separate hot and cold handles that you turn down until they stop. A rubber washer presses against a valve seat, so drips come from worn washers or a pitted seat. They’re the type most likely to drip, and common in older homes.
  • Cartridge faucets have one or two handles that move smoothly without tightening down. A replaceable cartridge controls the flow; drips usually mean worn cartridge seals or O-rings.
  • Ball faucets have a single handle over a rounded cap. A slotted ball with springs and rubber seats controls the flow, and those seats and springs wear out.
  • Ceramic disc faucets have a single lever over a wide cylinder. Two ceramic discs seal very well, so drips are less common and usually come from the rubber seals around them or from scale and grit on the discs.

If you’re not sure, the brand name on the faucet and a photo of the handle are usually enough for a hardware store or plumber to identify the parts.

How to Fix a Dripping Faucet

Before you take anything apart, find out which side is dripping: close the hot shutoff under the sink and watch the spout for a few minutes. If the drip stops, it’s the hot side; if not, open it and try the cold. That way you replace only the part that’s worn.

  1. Turn off the water at the shutoff valves under the sink, then open the faucet to drain it.
  2. Plug the drain so small parts don’t fall in.
  3. Remove the handle: pop off the decorative cap and unscrew the handle screw.
  4. Remove the cartridge or stem. Note the orientation, or take a photo.
  5. Take the old part to a hardware store to get an exact match (cartridges are brand-specific).
  6. Replace the cartridge, or the washer and O-ring, and clean scale from the valve seat.
  7. Reassemble, turn the water back on slowly and check for drips.

If the faucet still drips, the valve seat may need replacing, or the faucet itself may be worn out.

Check Your Water Pressure

A hose-bib pressure gauge tells you in a minute. Household pressure is typically 40 to 80 psi; California’s plumbing code calls for a pressure regulator above 80 psi. High pressure also strains toilets, water heaters and hoses.

What Fixing a Dripping Faucet Costs

Fix Parts Who usually does it
Washer and O-ring replacement (compression faucet) Very low (a repair kit) DIY or plumber
Cartridge replacement Low (one brand-specific cartridge) DIY or plumber
Valve seat cleaning or replacement Low (a seat and a seat wrench) DIY or plumber
Pressure-reducing valve (pressure above 80 psi) Valve and fittings Plumber
New faucet Faucet plus installation Plumber, or DIY for a simple swap
CPI service visit (San Jose) Quoted as a fixed price before work starts, typically based on $150–$250 per hour plus parts and drive time ($200–$300 after hours, with a minimum charge) Plumber

Prices checked October 2026. CPI's current $50 off any plumbing service special applies to faucet repairs.

For a faucet in good condition, a new cartridge or washer is the cheapest fix. If the faucet is old, corroded or its parts are discontinued, the labor to repair it can come close to the cost of replacing it, so ask for both prices.

When to Call a Plumber

  • The faucet still drips after you replace the cartridge or washers
  • Water leaks from the base or under the sink
  • Shutoff valves are seized or leaking
  • The faucet body is corroded or parts are no longer available

A plumber can repair or replace the faucet and check the pressure. For other drips and leaks, see toilet repair cost, how to detect water leaks and 20 common plumbing problems.

Is Your Toilet Making a Hissing Sound?

A hissing toilet is the dripping faucet’s noisier cousin: water is escaping somewhere, usually for one of three reasons.

  • A faulty fill valve. If it doesn’t shut off fully, water keeps flowing into the tank and hisses.
  • A leaking flapper or tangled chain. Water trickles from the tank into the bowl, and the fill valve keeps topping it up. EPA WaterSense suggests a quick test: put a few drops of food coloring in the tank and wait 10 minutes; color in the bowl means a leak (EPA).
  • High water pressure. Excess pressure can push the tank’s water level up to the overflow tube.

Start by adjusting or replacing the fill valve or the flapper; both are inexpensive parts. See toilet repair cost if you’d rather have a plumber do it.

Preventive Plumbing Tips

  • Check faucets and toilets regularly for drips, hissing or water around the base.
  • Consider a water softener if scale builds up quickly on fixtures; it reduces the mineral deposits that wear seals and valve seats.
  • Keep water pressure between 40 and 80 psi, with a pressure regulator if it’s higher.
  • Fix small leaks right away. A worn washer or cartridge is a quick, inexpensive repair; water damage under the sink isn’t.

Dripping Faucets in San Jose Homes

  • Hard water wears cartridges, seals and valve seats.
  • Older faucets in 1950s to 1970s homes may need replacing rather than repairing.
  • Water pressure: if your pressure is above 80 psi, a regulator protects every fixture.

CPI Service repairs and installs faucets throughout San Jose and the South Bay. See faucet repair and installation, request a free estimate or call (408) 978-3093.

Frequently Asked Questions

How much water does a dripping faucet waste?

More than you'd think. EPA WaterSense notes that household leaks, including dripping faucets, waste more than 9,300 gallons a year in the average home.

Why does my faucet drip more at night?

Water pressure often rises when demand in the neighborhood drops, which can push water past worn seals. If pressure is above 80 psi, a pressure regulator helps.

Should I repair or replace a dripping faucet?

Replace the cartridge or washers on a faucet in good condition. Replace the faucet if the body is corroded, parts are no longer available, or it's old and keeps leaking.

How much water does one dripping faucet waste?

EPA WaterSense says a faucet dripping once a second can waste more than 3,000 gallons a year. A slower drip wastes less, but it never stops on its own.

How do I tell whether the hot or cold side is dripping?

Close one shutoff valve under the sink and watch the spout for a few minutes. If the drip stops, that side's cartridge, washer or seat is the problem. If it keeps dripping, open that valve and close the other one.

Why does my faucet still drip after I replaced the washer?

The usual reasons are a pitted or scaled valve seat that the new washer can't seal against, a replacement part that isn't an exact match, or water pressure above 80 psi. Clean or replace the seat, check the part number, and test the pressure.

Do I need to shut off the main water to fix a faucet?

Usually not. The shutoff valves under the sink isolate the faucet. If they're seized or leak when you turn them, close the main shutoff instead, and consider having the valves replaced while the plumber is there.

How much does a plumber charge to fix a dripping faucet in San Jose?

CPI quotes faucet repairs as a fixed price before work starts, typically based on $150 to $250 per hour plus parts and drive time. Most drips are a cartridge or washer swap, so the part itself is inexpensive; replacing the whole faucet costs more.

What a South Bay customer says

First I had a visit from Matt who said a couple parts had to be ordered for a phantom flushing toilet when no-one was near it. He took a long time explaining to me the problem and wondering why I never saved the guarantee (I bought the fixture in 2009). When he left, he said he would try to order parts. I was left guessing whether he would follow through or the faulty issue would continue forever. Lo and behold, the hero appeared in the form of Isaac after I spoke to the office manager, Denise, on the phone.. Isaac had purchased the parts and in late afternoon showed up to install them, which he did. Isaac was cheerful and efficient. The parts have a 90 day guarantee (plumbing law or something), but hopefully they will long outlive this. Way to go, CPI, for following up immediately to complete this job.

Danielle W., Yelp review

Read more reviews →

Serving San Jose and the South Bay

CPI Service is based at 2880 Aiello Dr in San Jose and serves homes and businesses across the South Bay and the Peninsula. See all the areas we serve.

Ready to get started with CPI Service?